PRESONUS FADERPORT 16 STAND - 20 degrees - 3D printed- 100% Buyers Satisfaction

Description

3D Printed 20 degrees tilted
STAND
with rubber pads for
PRESONUS FADERPORT 16
DAW controller
For FADERPORT8
here is another stand:
https://www.ebay.com/itm/33374249508
NEW! You can protect your PRESONUS FADERPORT16 easily against dust and spilled liquid with a DUSTCOVERPRO:
https://www.ebay.com/itm/333958229041
Forget the heavy or big laptop stands and weird unstable things like books to lift your beauty Faderport 16.
This stand allow you to use PreSonus Faderport 16 on your desk more ergonomic and
READ BETTER THE LITTLE DISPLAYS.
Stable feel,
no sliping, free of wobbling.
Easy
installation without glueing,screws or any tools.
Easy handle the stand and your device together as a
cohesive system
without worrying about falling apart when moving.
The system
don't take up more space sideways
like the device own.
Really
lightweight
and strong enough.
No middle rods or any stabilizers.
Installation:
Due to the design of the device, the placement of the legs is a bit tricky but easy. First, hook the lower claws into the lower edge of the Faderport so that the foot runs parallel along the rubber feet of the device. Once the lower part is stuck, pull and lift the rear claws over the upper edge at the same time, then release the upper claw. The spring force of the upper strong clip keeps the foot tight. The recesses surrounding the faderport’s own rubber feet prevent the foot from sliding to the side. No matter which foot you place first those are swappable because both feet are punched in the same way to access the power connector.
Pros:
Very stable!
Really lightweight and strong enough.
There is no connecting rod at the rear.
Together with these legs, you can handle the as a cohesive system without worrying about it falling apart.
It is
portable, easy to detach and attach again
MAIN FEATURE: It will be tight enough to stand perfect on your desk without slip or wobble.
-----------------------------------------
About st3nD tabletop stands:
All products are made with 3D printing, followed by some post-processing: deburring, sanding, surface cleaning.
The main goal
is to develop and manufacture high quality table stands with the following features:
Easy
installation without glueing,screws or any tools.
Stable feel,
no sliping, free of wobbling.
Easy handle the stand and your device together as a
cohesive system
without worrying about falling apart when moving.
The system
don't take up more space sideways
like the device own.
Really
lightweight
and strong enough.
No middle rods or any stabilizers.
Portable
so you can bring it to your live gig easily.
These are the considerations I keep in mind when design and making stands.
I try to lower prices as low it possible for save your bucks but look after the quality too. I manufacturing these products one by one. So these handmade stands are different than mass products. This is the reason why they are not so so cheap as I want it too. I will make the stand for you, just for you, so you can focus using your device more ergonomic.
Please check my other stands for various brands as
: Native instruments, Maschine, Ableton, Roland, Akai, Arturia, Digitakt, Novation, Roland Boutique Series:
https://www.ebay.com/str/st3nd
IMPORTANT:
The device is only an illustration for the stand, which is not part of the sale!
Shipping is depend printing que, printing time, and your country distance and shipping conditions (please be patient due covid delays :) )