HENKEL LOCTITE LB C-200 1.3 LB HIGH TEMPERATURE SOLID FILM LUBRICANT 39893

Description

NEW Henkel Loctite 39893 LOCTITE LB C-200™ Known As Loctite C-200 Net Wt. 1.3 lbs. (590g)
Some cans might have a slight dent. Expiration Date 04/21
LOCTITE LBC-200 Known as Loctite C-200TM
PRODUCT DESCRIPTION LOCTITE LB C-200 provides the following product characteristics: Technology Molybdenum-disulfide based Appearance(uncured) Dark gray smooth paste LMS Components One component - requires no mixing Cure Airdry with optional heat cure Application Lubrication Specific Benefit ● High temperature ● Heavy-duty static loads ● Will not attract dirt or dust
LOCTITE LB C-200 is a molybdenum-disulfide based solid film lubricant. It is used by manufacturers of military and commercial jet engines. In soft paste form, this product brushes on easily. Typical applications include production, aerospace, automotive, heavy equipment, and electrical. This product is typically used in sliding friction at an operating range of -29 °C to +398 °C. For anti-seize lubrication, LOCTITE® LB C-200 functions from-29 °Cto+1315°C.
TYPICAL PROPERTIES OF UNCURED MATERIAL Specific Gravity @ 25°C 1.3 to1.6LMS Density, DIN EN542 @ 25°C,g/ml 1.44
Flash Point - See MSDS
Penetration, ISO 2137, unworked,1/10 mm 330 to390LMS Coverage,0.0177 mm () 55.7 m² per 3.78 l
TYPICALCURINGPERFORMANCE Any of the following cure schedules will cause LOCTITE® LB C-200 to thermoset, making it fluid and solvent resistant. Cure Schedule @ 260 to315°C,30 minutes @ 232°C,60 minutes @ 204°C,2 hours
TYPICAL PERFORMANCE
An anti-seize lubricant used on a bolt helps to develop greater clamp load for the same torque compared to an unlubricated bolt. An additional benefit is greater uniformity in clamp load among a series of bolts. The relationship between torque and clamp load is expressed in the following equation:
T=KxFxD
T=Torque (N·m,lb.in,lb.ft) K=Torque coefficientor nut factor, determine experimentally F=Clamp load(N,lb.) D=Nominal diameter of bolt(mm,in.)
Torque coefficient, k: 12.7 mm steel bolts(grade 8) and nuts (grade 5)
0.13
12.7 mm steel bolts(grade 8) and nuts (grade 5), solvent cleaned, not lubricated
0.27
TYPICAL PROPERTIES OF CURED MATERIAL Physical Properties: Melting Point, °C ≥65LMS Draw Down - #2 Draw down on Steel No flaking when scratched with a blunt object  LMS
GENERAL INFORMATION This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Material Safety Data Sheet(MSDS).
Surface Treatments Compatible With Lubricant Aluminum and Magnesium Anodize coatings Carbon Steel Phosphate coatings Stainless Steel Passivated with acid and dichromate Titanium Phosphate fluoride treatment
Directions for use: 1. May be applied by brushing, dipping or spraying directly to clean metal surfaces. 2. Prior surface treatments -- common metal protecting conversion coatings -- can be used to enhance corrosion resistance and wear life.
Loctite Material Specification LMS